Links are not yet activated.
Is this your press release? Add a link to submitpr.org on your website and verify it — activation is instant and free.
Or upgrade once for permanent activation (from $19.95, pay with crypto).
WUXI, China — Wuxi Runda Dye-Finishing Equipment Factory publishes three heat-source options for the JRD series hot-air stenter: heat transfer oil, city gas, or electric heating. Mills can match the oven to the energy already available on site instead of redesigning the utility room around a single heater type. The factory also publishes an overfeed range of −10% to +100% and fabric holding by pins, clips, or a combined pin-clip chain.The JRD is a hot-air circulation stenter used for dewatering, finishing, drying, baking and heat setting of woven and knitted fabrics. Cloth is held at both selvedges and carried through a row of hot-air chambers so drying, width setting and heat setting can take place in the same pass. Because the oven is a standard hot-air chamber, it is also used to cure resin finishes after padding and to bake coated fabric at moderate temperature. Heat source, drive side (left or right), number of oven sections, and working width are confirmed per order.
Nominal width is 1,800–3,400 mm, with width adjustment from 900 to 3,200 mm. Nominal speed is 100 m/min. Oven temperature is published at 220 °C. Oven sections are N sections of 3 m each. Fabric delivery may be swing or roll. Edge sensing is high-precision infrared on a cast-iron rail. An example installed capacity is given as 130 kW for an 8-section, 180 model.
Overfeed from −10% to +100% covers knit constructions that need positive overfeed as well as wovens that must be held closer to draft. Pin chains, clip chains or combined pin-clip chains let the mill choose how selvedges are gripped. Accessories listed on the product page include a three-finger silent expander for knit and woven fabric, a synchronized brush overfeed and pin-pressing device with variable-frequency control, and cloth-edge tracking with infrared sensing. Entry and delivery combinations can be selected by the customer.
Typical published uses include heat setting of polyester and polyester-blend woven and knit fabric, drying and width setting after dyeing or padding, and curing of resin and soft-hand finishes. When you enquire, send fabric type and weight, the widest cloth width, speed or daily output, the process (dry, set or cure), the heat source and the destination.
About Wuxi Runda Dye-Finishing Equipment Factory
Backed by the Wuxi Qianzhou textile dyeing and finishing machinery platform, we can supply virtually the full equipment line and deliver an optimized solution for the mill. German technology, built in China — licensed airflow dyeing technology from Germany, manufactured locally in Wuxi, China, combining European engineering quality with local pricing. The factory’s patented 16-tube RD HT airflow dyeing machine is published at a liquor ratio of 1:2.5 (cotton as low as 1:3–1:3.5, synthetics as low as 1:2–1:2.5). Other published lines include the SWRl400 jumbo jigger, the JRD hot-air stenter (1,800–3,400 mm, oven 220 °C), and HTHP overflow dyeing machines (maximum 145 °C, liquor ratio 1:6–1:12). Founded January 2004 in Qianzhou, with a workshop of about 3,000 square meters. Export markets include Vietnam, India, Bangladesh, Indonesia, Pakistan, Japan and Thailand.
Heng Bao
+86 13382239366
bao@runda2008.com
https://www.runda2008.com/