Links are not yet activated.
Is this your press release? Add a link to submitpr.org on your website and verify it — activation is instant and free.
Or upgrade once for permanent activation (from $19.95, pay with crypto).
For most U.S. potable water mains, cement-mortar lining is the standard internal protection for ductile iron pipe. Applied at the plant under ANSI/AWWA C104/A21.4, the lining shields the iron from corrosion and preserves hydraulic capacity. A seal coat is a thin asphaltic layer applied over that freshly placed cement-mortar lining. It does not replace the lining; it is a supplementary barrier on top of it.Seal coats first appeared in the 1953 edition of C104 as a way to control mortar curing by holding in moisture. Field experience revealed a second benefit: the coating helps retard leaching of cement by soft, aggressive water.
That matters because water chemistry drives lining performance. Soft water with low hardness and alkalinity tends to dissolve calcium hydroxide from the mortar. In low-flow sections, dead ends, or new mains with long residence times, leaching can raise pH and alkalinity, complicating corrosion control and disinfection. By limiting direct contact between water and mortar, a seal coat reduces that exchange, particularly during early service.
It is not a universal requirement. Under C104, the seal coat is optional unless the purchaser specifies it. The decision should rest on source-water chemistry, operating conditions, and utility standards. Engineers should also check service limits, since manufacturers typically rate seal-coated linings for lower water temperatures than plain cement linings.
Compliance involves two separate questions. ANSI/AWWA C104 governs how the lining and seal coat are manufactured and verified. NSF/ANSI/CAN 61 addresses health effects, confirming that materials contacting drinking water do not leach contaminants above acceptable levels. Meeting C104 does not demonstrate NSF/ANSI/CAN 61 compliance, and most state regulators and utilities require that certification separately.
Rashmi Metaliks USA supplies centrifugally cast ductile iron pipe and fittings for North American potable water systems. Lining and seal coat selection deserves the same scrutiny as pressure class and joint type. Utilities, consultants, and contractors can contact Rashmi Metaliks USA for project-specific lining options, certification documentation, and technical data sheets.